Packaged differential mode enhanced AC single-phase power supply filter
Product features
r
◆Single-phase differential mode enhanced C series, one-level common mode plus one-level differential mode filter circuit , containing independent differential mode inductors, good electromagnetic interference suppression characteristics
◆Can effectively suppress the wide-band electromagnetic interference caused to the power grid when the power switch tube operates
◆Solve the following problems of exceeding the standard in the conducted emission test
◆Rated operating current>,
Can withstand >- times the instantaneous overcurrent and is used for power electronic equipment below power.
>Can be customized according to different performance, operating current, voltage, external dimensions and termination methods
>Usage occasions
Used to solve problems involving switching power supplies, >, and intermediate frequency Electromagnetic interference problems in power supplies and other equipment or systems
◆Can also be used for motor drives, power inverters, etc.
Technical parameters:
/C
Rated current R
Operating frequency r rc
/
C
Line to ground
C
Maximum leakage current
.(C@)
Temperature range R
+>>℃
< Termination method r
Input terminal
Output terminal
Power cord
Power cord
◆ Insertion loss
r B
>
Common mode (C), differential mode/
Measurement Systems, B/CR .Publications , B .
Frequency (
)
.
.
.
.
.
.
.
Common
Model
Poor
Model
◆ Circuit type
:< Circuit diagram/>
◆ Overall dimensions (package)
:< B package size diagram/>
◆
Installation tips:
Installation location: The best location for filter installation should be at the entrance of the power cord to shorten the length of the input wire in the chassis and reduce spatial coupling of radiated interference
Grounding: of the filter Grounding must be good. For filters with metal shells, the shell must be connected to the equipment chassis with low impedance, that is, the shell must be in conductive contact with the chassis panel and connected to the ground wire
Wiring of the input and output ends of the filter: input line of the filter , The output lines must be kept apart, and avoid running parallel lines to avoid coupling between the input cable and the output cable and bypassing the filter, causing the filter to fail.
◆
Reference Standards
[] B/― Part 1 General Specifications for Integrated Filters to Suppress Radio Frequency Interference
[] B/― Integral Filters to Suppress Radio Frequency Interference Part II Specifications for Filters
[] ― Safety Standards for Electromagnetic Interference Filters